FIRE Light is on to indicate fire alarm flashes to indicate a trouble condition with your fire system. They do not support an area list for systems that support areas, area control. INSTANT Light is on when there is no entry/exit delay. NOTE: The systems listed above support keypad emulation. The basic premise is not much different than the wireless firefighter unit which monitors for the audio of interconnected devices, but may differ due to supervision capability in the firefighter or the fact it does not physically tie into the circuit. NX-8V2 SYSTEM KEYPAD Includes models ARMED Light is on when NX-108E, NX-116E, NX-124E armed off when disarmed flashes to indicate a previous alarm. before) and ONE SINGLE smoke detector hooked up to the Networx panel. I think due to UL, the manufacturer instructs users not to do it. Hello - we have successfully connected our NX8V2 to SuretyDIY via the. ![]() I believe it is still within fire code to do so (use the relay) but you would need to check with your local authority. Under UL certification, monitored smokes have different requirements than non-monitored, so there are two separate certifications. Start off with a fast pack which included the. Instead it is for non-monitored sirens, alerting devices, etc. We carry the GE NX-8V2 alarm panel and accessores which include the 148RF keypad to support wireless sensors. The manufacturer recommendation is to not use the SM120X for a series of smokes and an Alarm control panel. If more than one smoke detector is in the circuit, using builder provided 120VAC smokes, there is no way of telling which tripped. See the attached capture from the manual. ![]() In the meantime, why? Why put in one orphan detector when there’s a whole interconnected loop which could just have a relay to connect to the control panel?įrom what I understand, this is likely due to UL and manufacturer.
0 Comments
Leave a Reply. |